Dodge 9 1/4 rear end??? will it fit
#1
Senior Member
DYNO OPERATOR
Thread Starter
Join Date: Mar 2009
Location: Booneville,Ms
Posts: 505
Dodge 9 1/4 rear end??? will it fit
Last night at the dragstrip I came up on a 9 1/4 Dodge truck rearend and was wondering if it would fit under a 1985 camaro and if so what modifications will need to be done. Thank you :?: :?: :?: :?:
#2
Senior Member
RACING JUNKIE
Join Date: Jan 2006
Location: La.
Posts: 2,890
You can make anything fit, but that would be total overkill. By the time you had it narrowed, new axles, etc. you would have spent possible a $1,000.00. The bigger/heaver you go the more HP it take to spin the rearend. Why don't you just look for 12 bolt chevy or a 9" ford out of an early mustang or mercury. It's close to the right width and 1/2 the weight.
JMO
Zip.
JMO
Zip.
#3
Senior Member
DYNO OPERATOR
Thread Starter
Join Date: Mar 2009
Location: Booneville,Ms
Posts: 505
i ran up on a deal and i'm only 15 have a fairly good job for my age but i'm still paying for the car so im building a low budget build and im a redneck and dont care what it looks like i'll leave them tires hanging out the side but thnx for tha advice but im and i dont care bout speed just consistancy but anyways thanx for tha advice