Results 1 to 2 of 2

Thread: Ford 410" stroker questions

  1. #1

    Ford 410" stroker questions

    I'm building my first stroker engine.Also my first performance engine. We installed the crank and rods/pistons and everything went well.No clearance issues. We put the heads on after checking the piston/valve clearances,all ok. We installed the cam,lifters, pushrods and rockers then set lash. When we roll the crank over through the intake/exhaust strokes there is a pop. The heads just had new springs,valves, retainers and locks installed by the machine shop. We checked the push rod lengths and there dead on center. We only have .0065 on the springs. Is this enough clearance or are we at coil bind or ???
    HELP !!!!
    Thanks
    Mike L in Ga

  2. #2
    Senior Member RACING JUNKIE
    Join Date
    Jan 2006
    Location
    La.
    Posts
    2,890
    I would say absolutly not enough clearance, i don't like to see less than .100 before coil bind.

    JMO

    Zip.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy