Results 1 to 2 of 2

Thread: Fresh Motor Break in??

  1. #1
    Senior Member MASTER BUILDER
    Join Date
    Feb 2008
    Location
    New Jersey
    Posts
    133

    Fresh Motor Break in??

    Hello All

    So this is my first motor that i had freshened up and am NOT putting it on a dyno before i go out.
    This motor has new rings, cam, valve springs, lifters main brgs
    Should i use one of the numerous break in oils? Is there some procedure i should follow?

    Thanks
    Keith.

  2. #2
    Senior Member DYNO OPERATOR
    Join Date
    Aug 2005
    Location
    Rifle Colorado
    Posts
    585
    I've always run the same oil I intend to run after break-in. Fire it up, turn the idle up to around 2500 and let it run for about 20 minutes. Check for leaks, check the timing, adjust idle speed & mix, check and adjust valves, take it to the track and let it fly! No easy "break-in" passes. It'll break in better if you just run it full out......I'd change the oil & filter after the first day at the track and maybe cut the filter apart to inspect. Some will change the oil after the initial run-in. It's really a preference thing. JMO
    Johnny


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy