Sealing scoop to carb
12-22-2009, 04:06 PM
Junior Member
SHOW GUEST
Thread Starter
Join Date: Jan 2009
Posts: 2
Sealing scoop to carb
I am installing a aero scoop on my car wanted to know if i can use 3/16 aluminum plate or is it to heavy to mount directly to carb thanks.
12-23-2009, 09:59 AM
Senior Member
RACING JUNKIE
Join Date: Jan 2006
Location: La.
Posts: 2,890
That sounds heavier than necessary too me. On my injection engine i'm useing 1/16" tk., because that's the material i already have, but .040 would be tk. enough.
JMO
Zip.
12-23-2009, 11:40 AM
Senior Member
DYNO OPERATOR
Join Date: Aug 2007
Location: Lost Creek, WV
Posts: 533
The panel between my scoop and carb is .040 and works fine. JMO!
TS1955
12-23-2009, 11:44 AM
Senior Member
RACING JUNKIE
Join Date: Dec 2008
Location: Sugar Hill, GA
Posts: 1,365
I used 3/16 on my door car and then crushed the foam about 20% with the hood to get a good seal. I was afraid the lighter stuff would flex.
JMO
Dave
01-01-2010, 08:01 PM
Junior Member
SHOW GUEST
Join Date: Dec 2009
Posts: 1
bonnett scoop
when i did my car i used a 14" aircleaner base and foam to seal carbie to bonnett worked real well
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off