Results 1 to 6 of 6

Thread: blower ?

  1. #1
    Senior Member EXPERT BUILDER
    Join Date
    Jan 2007
    Location
    atwood,Ky
    Posts
    302

    blower ?

    i need to know the torque spec. on a 6-71 bds street blower.thank for any help,john

  2. #2
    Senior Member RACING JUNKIE
    Join Date
    Dec 2004
    Location
    austin texas
    Posts
    729
    torque what? The aluminum studs,bolts,timing gear bolts or what?

  3. #3
    Senior Member EXPERT BUILDER
    Join Date
    Jan 2007
    Location
    atwood,Ky
    Posts
    302
    sorry ops: ,the stud that bolt the blower to the intake

  4. #4
    Senior Member RACING JUNKIE
    Join Date
    Jan 2006
    Location
    La.
    Posts
    2,890
    Install the bolts into the maniflod useing anti-sez by hand, then set the blower on the maniflod with gaskets, torque nuts useing flat washers to 25 ft.lbs. with anti-sez also working from ctr. out useing criss/cross patern.
    Hope this helps.

    Zip.

  5. #5
    wieand 8-71 is only 12 lbs........25lbs might be to much...

  6. #6
    Senior Member RACING JUNKIE
    Join Date
    Dec 2004
    Location
    austin texas
    Posts
    729
    Haha, my last two blown motors i have used steel 7/16 bolts!


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy