Results 1 to 5 of 5

Thread: PCV Question

  1. #1
    Junior Member APPRENTICE
    Join Date
    Jun 2008
    Location
    Buckner, MO
    Posts
    11

    PCV Question

    Does anyone use anything like this?:

    http://store.summitracing.com/partde...5&autoview=sku

    I currently have an inline filter (air/oil seperator) in my pcv system but I was thinking of eliminating it all together for a system like this. I've been told it can free up some more power. Is there any negative impact on this type of setup or is the "drag race use only" disclaimer for emissions?

    Thanks,

    Josh
    96 Z28, 385 spalyed 4 bolt LT1, N/A, M6, LE top end, MW Chassis Fab 9, & all the other stuff
    V299 local series, NMCA OC 9004

  2. #2
    Junior Member APPRENTICE
    Join Date
    Jun 2008
    Location
    Buckner, MO
    Posts
    11
    OK, I posted a link to Summit that works this time! Sorry!
    96 Z28, 385 spalyed 4 bolt LT1, N/A, M6, LE top end, MW Chassis Fab 9, & all the other stuff
    V299 local series, NMCA OC 9004

  3. #3
    Senior Member EXPERT BUILDER
    Join Date
    Jan 2007
    Location
    atwood,Ky
    Posts
    302
    i've used them for years & i like them pretty well,just switched to a vac. pump and its great. i would try them if i where you they aren't going to hurt nothing.jmo good luck,john

  4. #4
    Senior Member DYNO OPERATOR
    Join Date
    Aug 2005
    Location
    Rifle Colorado
    Posts
    585
    It is a race only part as it relies on unrestricted exhaust flow to work. I'm pretty sure that mufflers will cause enough backpressure to prevent them from working....

  5. #5
    Junior Member APPRENTICE
    Join Date
    Jun 2008
    Location
    Buckner, MO
    Posts
    11
    Thanks, that's what I wanted to know. I've seen em on race cars but never on cars that see any street time. I have 3" exhaust into a 1 chamber Flomaster turned down under the rear right seat. It sounds like these are more for higher rpm open header setups.

    Thanks, :wink:

    Josh
    96 Z28, 385 spalyed 4 bolt LT1, N/A, M6, LE top end, MW Chassis Fab 9, & all the other stuff
    V299 local series, NMCA OC 9004


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy