Results 1 to 2 of 2

Thread: Procharger Motor build up Help

  1. #1
    Senior Member MASTER BUILDER
    Join Date
    Mar 2003
    Posts
    127

    Procharger Motor build up Help

    I want to build a Procharger motor, but this is for a 9.90/10.90 Car. .

    I would like some input on the motor program.

    I would like to build a 480-500 BBC
    10-1 pistons
    Alum Heads
    Alcohol Mechanical Injection
    20 psi Boost

    I know that most of these motors are low compression gas carb or elec fuel injection.

    Do I build the motor like our Blown SBC Top Dragster deal.
    Alum Rods, 11.5-1 pistons
    Or
    Can I/Should I build it with good steel rods and a good crank

    What do these guys with 565 BBC and 12-1500 HP have for internals?

  2. #2
    Junior Member SHOW GUEST
    Join Date
    Apr 2005
    Posts
    5
    If it were mine it would have at least 11.5 for compression and aluminum rods, but you could probably get by with steel rods at that power level


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy