Results 1 to 2 of 2

Thread: TH400 Shifter linkage

  1. #1
    Member JUNIOR BUILDER
    Join Date
    Apr 2007
    Location
    West Palm Beach, Florida
    Posts
    71

    TH400 Shifter linkage

    I have a th400 and Hurst quarter stick. Manual valve body reverse pattern. The shifter shaft going in the side of the tranny has play that keeps me from adjusting the shifer.

    At first I thought I adjusted wrong, PRN12 were good, but no 3rd gear. Readjusted and had to go to reverse to get neutral. The shifter arm on the tranny is tight and moves tight with the shaft.

    I was told to drop the pan and filter and tighten a 9/16 nut on the shifter shaft where it goes through the case and that will fix it.

    Can anyone confirm this before I waste time and do something stupid?

    Steve

  2. #2
    Member JUNIOR BUILDER
    Join Date
    Apr 2007
    Location
    West Palm Beach, Florida
    Posts
    71
    I dropped the pan and sure enough, three flats to tightenup the nut that holds the cam plate tight to the shifter arm.

    Back in business.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy