Results 1 to 2 of 2

Thread: CARBURETOR WEDGE

  1. #1

    CARBURETOR WEDGE

    What do you guys think about taking a phenolic carb spacer and milling an angle on it to make the carburetor sit level.Will it mess with any tuning or the way it runs,and should the carb be perfectly level? Thanks

  2. #2
    Senior Member MASTER BUILDER
    Join Date
    Nov 2004
    Location
    Port Sulphur, La.
    Posts
    139

    wedges

    I dont know about a dominator wedge, but it was common. and in most cases necessary down here to run all kind of wedges on the gas motors because of the angle the way they sat in the trawl boats. Try a marine supply, should have them in an assortment of thicknesses. Good Luck.

  3. Racing Junk


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy