Results 1 to 3 of 3

Thread: Jesel comp series lifter torque

  1. #1
    Senior Member MASTER BUILDER
    Join Date
    Oct 2003
    Posts
    144

    Jesel comp series lifter torque

    I'm installing a set of competition series Jesels on a set of 23* heads and need to know how much to torque the stands and shaft bolts. I went on Jesel and could not find the correct application.
    They have the stands at 60-65 and the shafts at 26-28 lbs, is this correct?
    need to get it back together for this weekend.
    Any help apreciated.
    thanks
    Al

  2. #2
    Senior Member MASTER BUILDER
    Join Date
    Nov 2004
    Location
    Port Sulphur, La.
    Posts
    139

    jesels

    You are correct for alum heads.65-70 for iron. The bolts hooking the stands together are 12 lbs, and the adjuster nuts are 25 lbs. Watch that the rockers line up straight with the valves. On my dart 360s I had to put a .030 shim between the stands to kick 8 of the valves over to line up straight. If this is the 1st time, make sure the stands dont sit on top of the head studs, a few of mine did and had to cut the top of the stud down. Good Luck,TC This is a BB?

  3. #3
    Senior Member MASTER BUILDER
    Join Date
    Oct 2003
    Posts
    144
    Small block chevy,
    thanks for the info.
    there were no spacers in the setup when I got it.
    AL


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy