Results 1 to 4 of 4

Thread: Help Needed Please

  1. #1

    Help Needed Please

    Ok guys, I need a favor please. I am using a Progressive Instruments nitrous controller. It is a multi stage controller nitrous controller. Without the solenoid wires hooked up to the controller the controller will delay and pulse as programmed perfectly. Now when I hook the solenoid wires up to the controller the first stage will delay and pulse as required but when the second and third kit comes on all stages sit there and pulse until you let off the microswitch. I have double checked that the solenoid wires are correct. Now here is the other odd part, if I was to activate, delay, and pulse each stage individual they work perfect but when 2 or more stages are activated they do this pulsing effect. It is almost like when 2 or more stages are activated that it is drawing too much amperage somehow. Each stage has it's own relay but constant hot going to all nitrous relays are all from the same wire but is a 12 gauge wire. Any help will be greatly appreciated.
    Thanks,
    Travis

  2. #2
    Senior Member DYNO OPERATOR
    Join Date
    Aug 2005
    Location
    Rifle Colorado
    Posts
    585
    May be a ground problem. Either with the controller or the relays. Do all the relays ground at the same location? Try running a jumper from the ground point to the battery neg post and retest....

  3. #3

    Thanks

    I will try that. Thanks.

  4. #4
    Problem fixed. Had to add another hot source to the #30 on my relays. Works perfect now. Thanks


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy