Results 1 to 3 of 3

Thread: Manual Valve body help!!!!!!!!!!!

  1. #1
    Senior Member SENIOR BUILDER
    Join Date
    Oct 2005
    Location
    Wellington , New Zealand
    Posts
    122

    Manual Valve body help!!!!!!!!!!!

    When installing a TCI Manual reverse valve body into my powerglide it says to remove govner assembly.What parts do you take out and what parts do you leave in?????

  2. #2
    Senior Member MASTER BUILDER
    Join Date
    Dec 2003
    Posts
    185
    Remove all that is connected to the governor support and you should be left with this....
    http://www.tsr-racing.com/shop/image...PG-28859-L.jpg

  3. #3
    Junior Member APPRENTICE
    Join Date
    Nov 2005
    Posts
    16
    Quote Originally Posted by sg1586
    Remove all that is connected to the governor support and you should be left with this....
    http://www.tsr-racing.com/shop/image...PG-28859-L.jpg
    Yes, but if it was an original rear pump type support, you will need to use a blocking plate under the support.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy