Header Question on a 632
03-09-2008, 02:53 PM
#1
Member
JOURNEYMAN
Thread Starter
Join Date: Nov 2005
Location: Baltimore
Posts: 30
Header Question on a 632
I have a 72 Chevelle ansd am putting together a 632 10- 1/2 to 1
motor. with the tall deck what headers do I need will hooker Super Comp work or do I need special Headers.
motor. with the tall deck what headers do I need will hooker Super Comp work or do I need special Headers.
03-11-2008, 06:32 AM
#2
Member
JUNIOR BUILDER
Join Date: Jan 2004
Location: Wisconsin
Posts: 65
Headers
What heads are you running on the engine? With the T/D and any head with a raised exh. port you are going to have some problems. If the front stub has been done you have a better chance of getting some to fit.
But be ready to change a few tubes, it may be your only hope. Super Comps. in my Nova 540 T/D .400 raised exh. port We changed 4 tubes, and the front stub was done. Plated, crossmember cut, and a rack.
You can try Kooks, or Lemons they may have something that might work? But they will cost almost as much as a fabbed set will run you.
Good Luck
But be ready to change a few tubes, it may be your only hope. Super Comps. in my Nova 540 T/D .400 raised exh. port We changed 4 tubes, and the front stub was done. Plated, crossmember cut, and a rack.
You can try Kooks, or Lemons they may have something that might work? But they will cost almost as much as a fabbed set will run you.
Good Luck
