U-weld it sheet metal intake kits
#1
Junior Member
JOURNEYMAN
Thread Starter
Join Date: Feb 2008
Posts: 29
U-weld it sheet metal intake kits
Looking to replace the two dominator sheet metal intake that was stolen from my shop.....saw on racing junk the company selling kits that can be welded by the buyer. has anyone run one of this company's intakes either in a pre-welded version or purchased a weld it your self version and completed it?
It is going to be used on a 632 nitrous motor .....big chief heads...the usual junk.....
It is going to be used on a 632 nitrous motor .....big chief heads...the usual junk.....
#4
Senior Member
MASTER BUILDER
Join Date: Apr 2006
Location: Ms.
Posts: 191
Here is one ready to go almost as cheap as the u weld kit
http://www.racingjunk.com/post/11404...AL-INTAKE.html
This is not my ad, just something I found
http://www.racingjunk.com/post/11404...AL-INTAKE.html
This is not my ad, just something I found
#6
Senior Member
MASTER BUILDER
Join Date: Apr 2006
Location: Ms.
Posts: 191
Keep in mind if you do the uweld kit, there is some serious porting that will have to be done also. I considered that route, but instead went with Beck Mechanical in Houston Tx. for a new one.
His website is WWW.Beckmechanical.com
His website is WWW.Beckmechanical.com