Results 1 to 3 of 3

Thread: drive line to trany angle

  1. #1
    Junior Member JOURNEYMAN
    Join Date
    Jan 2008
    Posts
    29

    drive line to trany angle

    what the best angle from tranny to driveline angle? mine looks like 5 degrees is that to much?

  2. #2
    Administrator RACING JUNKIE bjuice's Avatar
    Join Date
    Apr 2003
    Location
    Greenville s.c.
    Posts
    3,239
    1st off is it a ladder bar or 4 link ?

    where are you taking your measurement from ?

    i would say 5 degree of pinion is too much on any drive line..

    4 links can get away with 1 degree up to 2-2.5 ( max).. ( less is better)

    i cannot make anymore comments about your set up until you tell us more .

    Brian
    Bjuice..

    "I'M YOUR HUCKLEBERRY ! "

  3. #3
    Junior Member JOURNEYMAN
    Join Date
    Jan 2008
    Posts
    29

    tranny to drive line

    My camaro is a 4 link, i just got the car and it was all ready set up, they took out the small block and put a BB in it with motor and mid plate the back of the engine looks like its going down hill, then when you look under the car that reflects onto the driveline to tranny angle, the pinion angle looks pretty good, but i dont know how to check one.

  4. Racing Junk


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy