moroso spur gear pump question

Old 11-22-2007, 10:09 AM
  #1  
performanceengin
Member
JUNIOR BUILDER
Thread Starter
 
Join Date: Oct 2005
Location: ohio
Posts: 94
Default moroso spur gear pump question

i just purchased a 427 b/b with a moroso #22163 spur gear pump. gave engine a check up for clearances etc. reassembled,and when i went to prime system with a 1/2 drill i blew filter gasket out. put new filter on and tightened and spun it again. turning drill at about 100 rpm my 100# gauge is past 100lbs. is there an adjustment to lower pressure or what.. thanks for any advise :shock:
performanceengin is offline  
Old 11-22-2007, 05:41 PM
  #2  
jmarksdragster
Senior Member
RACING JUNKIE
 
jmarksdragster's Avatar
 
Join Date: Jul 2007
Location: Florida
Posts: 635
Default

Sounds like the regulator is hung. You will have to disassemble the pump.
jmarksdragster is offline  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -