Results 1 to 2 of 2

Thread: moroso spur gear pump question

  1. #1
    Member JUNIOR BUILDER
    Join Date
    Oct 2005
    Location
    ohio
    Posts
    94

    moroso spur gear pump question

    i just purchased a 427 b/b with a moroso #22163 spur gear pump. gave engine a check up for clearances etc. reassembled,and when i went to prime system with a 1/2 drill i blew filter gasket out. put new filter on and tightened and spun it again. turning drill at about 100 rpm my 100# gauge is past 100lbs. is there an adjustment to lower pressure or what.. thanks for any advise :shock:

  2. #2
    Senior Member RACING JUNKIE jmarksdragster's Avatar
    Join Date
    Jul 2007
    Location
    Florida
    Posts
    635
    Sounds like the regulator is hung. You will have to disassemble the pump.
    Mark Whitener
    http://racingfuelsystems.myfunforum.org
    __________

    Good work isn't cheap, and cheap work can't be good.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy