Results 1 to 3 of 3

Thread: same old roller lifter question

  1. #1

    same old roller lifter question

    so you hear that you should replace the lifters after 120 to 140 passes, if your running 1/8 mile is that now double the passes?

  2. #2
    Senior Member RACING JUNKIE
    Join Date
    May 2003
    Location
    Coldwater, MI
    Posts
    2,998
    I'd replace them, better safe then sorry IMO
    David Lanning
    IHRA NHRA 387B

    Fleenor Racing Transmission
    419-280-1406
    Lanning Electric
    Complete Drag Car Wiring
    APD Race Engines
    www.apdracing.com

  3. #3
    Senior Member MASTER BUILDER
    Join Date
    Dec 2005
    Location
    Rutherfordton North Carolina
    Posts
    192
    Check them and replace as needed. hold the lifter in your hand and press the roller toward the top of the lifter,then take a very small screwdriver or pocket knife blade and insert it between the lifter body and roller. while holding upward pressure with one hand pry the roller away from the lifter body. if there is more than .003/.005 movement replace the lifter. if when you roll the roller around with your finger there is any roughness to it replace it. if they check good run them for another cycle.Bill
    Hendrens Racing Engines
    1310 U.S. Hwy 221 North
    Rutherfordton N.C. 28139
    828-286-0780 Bill, Steve, Mike
    www.hendrensracingengines.com


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy