Results 1 to 1 of 1

Thread: Need help with Head's Intake etc

  1. #1

    Need help with Head's Intake etc

    :?: Am in the process of building a SBF,it's a standard bore 351,9.5" Deck,have purchased Venolia 6.1" Ali rods,Eagle Crank,and Diamond Nitrous Pistons 13:1,I want to run a Cleveland style cylinder head on my Windsor Block,can any body enlighten me a little as to a good combination? Want to run twin carb,tunnel ram set up and would like this to spin at around 7800-8500 rpm,engine will be in a 2000lb car with full manual c-4 with Dominator 4200 stall,and 9" with 4:56/31 spline axles any advice would be greatly appreciated appreciated.

  2. Racing Junk


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy