OK so it was just a Virtual dyno but it dynoed at over 600HP
Can this be even close? How accurite is a virtual dyno? The site says +/- 5%??
Here is what i got you tell me.
SBC 400 bored 40 over
Forged Crank/Pistons flat top
Brodix Track 1 mild port/complete port
Comp Cams:
Hydrolic Roller RPM RANGE 3000 TO 6500
PART # 12-460-8
CAM GRIND # 304HR
DURATION 304/304
DURATION @ 0.50 IS 244/244
VALVE LIFT WITH 1.5 ROCKERS IS .600/.600
LOBE SEPERATION ANGLE IS 110 DEGREES
Comp Cams Magnum Roller rockers
Brodix Dual Plane intake
Holley 4150 Pro Series 750
MSD Ignition:
6AL
Pro Billet Dist.
Blaster 2 coil
Edelbrock Gear drive
Holley Blue series fuel pump.
Well could it be close to 600HP??
I am in the middle of putting it in the car so i will know for sure in a week or 2 when i put it on the real dyno, but i am wondering.