9 inch axles respline?
does anyone know who can respline axles in ohio?or anywhere?
9 inch ford 28 spline and how much does it cost? |
moser in Indiana,best price, good job, fairly good turn around time about 2 weeks.
|
last time i had axles respline was a few years ago but mosser did them and did a very nice job..if i remember right it was $85.00 per axle but been a few years so i'm sure price is higher now..there is some nice aftermarket axles out there now that isn't much more in price..i didn't use respline axles with slicks but did use them back then for a street pro/street builds with the old hard m/t tires[steam rollers]
|
Re: 9 inch axles respline?
Originally Posted by liljon
does anyone know who can respline axles in ohio?or anywhere?
9 inch ford 28 spline and how much does it cost? Here's the site. http://www.quickperformance.com/ads.htm JMO Zip. |
My Moser's were $316 for the pair.I don't believe I would do it.Good axles are just too cheap to risk it.But I also ran high 6s(1/8 mile) on a 10 bolt with stock 28 spline axles,carrying a front tire for about 20 feet,with no problems(or c-clip eliminators :shock: )I'd still buy good axles.Just my opinion
|
Originally Posted by olds48
My Moser's were $316 for the pair.I don't believe I would do it.Good axles are just too cheap to risk it.But I also ran high 6s(1/8 mile) on a 10 bolt with stock 28 spline axles,carrying a front tire for about 20 feet,with no problems(or c-clip eliminators :shock: )I'd still buy good axles.Just my opinion
|
:shock: Never thought of that.Seriously, never crossed my mind.Ouch,that woulda sucked.Hard to find replacement panels for a 48 Olds. :shock:
|
Originally Posted by olds48
:shock: Never thought of that.Seriously, never crossed my mind.Ouch,that woulda sucked.Hard to find replacement panels for a 48 Olds. :shock:
|
see that on ford farm pu all the time around here. using 1/2 tons for 1 tons
|
All times are GMT -8. The time now is 12:54 AM. |