CURRIE REAR END
CURRIE REAR END WITH THE ALUMINUM CENTER HOUSING???[NOT THE PUMPKIN]--GOOD / BAD / OR THE UGLY?---MOSTLY STREET USE AND SOME 1/8 MILE--WHAT DO YOU THINK FOR MY RANCHERO GASSER?-LIVELY
|
Are you asking if its a good housing or are you selling it? :?:
|
looking at one and wondering about the strength and limits of it 8) 8) LIVELY
|
I think it would be fine for street use, but would stay away for race purposes.
|
I have been running Currie stuff for years with no problems... 9" N section, 4.88 pro gear and 35 spline spool and there race axles NO PROBLEMS HERE WITH 1.000 HP 866 Tq Eng in a 3150LBS CAR
|
Originally Posted by real3fann
I have been running Currie stuff for years with no problems... 9" N section, 4.88 pro gear and 35 spline spool and there race axles NO PROBLEMS HERE WITH 1.000 HP 866 Tq Eng in a 3150LBS CAR
|
Originally Posted by blittle
Originally Posted by real3fann
I have been running Currie stuff for years with no problems... 9" N section, 4.88 pro gear and 35 spline spool and there race axles NO PROBLEMS HERE WITH 1.000 HP 866 Tq Eng in a 3150LBS CAR
|
Look this guy up and have his rear end guy help you out.
http://rides.webshots.com/video/3026...01149359WVpyxw |
HE IS LUCKY HE DIDN'T LOSE IT ON THE PASS BEFORE!!!!---THAT IS ON THE PREVIOUS VIDEO 8) 8) 8) ----THE CURRIE REAR I LOOKED AT HAD THE ALUMINUM CENTER PIECE[WAS VERY NICE LOOKING BUT I WAS NOT SURE OF THE STRENGTH]---THANKS FOR THE INFO===LIVELY
|
Hello Lively,Just thought with your inquiry about the rear axle housing I have a 9" on the classified side if interested,Thanks Dragman28. :)
|
All times are GMT -8. The time now is 12:56 AM. |