Welcome to RacingJunk Classifieds, The World's #1 Motorsports Marketplace

For Sale: Stewart EMP high output electric water pump

Ultimate Intercooler Pump

Ad #182247765   Posted:2014-07-21 19:41:54

This ad expired 88 days ago.

Stewart EMP WP29 high output electric water pump / intercooler pump

Can be used as an intercooler pump, engine coolant pump, auxiliary coolant pump and many other uses.
One of the highest flowing electric water pumps available.
High flow and high pressure capability - flows over 29 gallons per minute (gpm) at 7 psi pressure.
This pump will continue to flow at over 25 psi differential pressure.
Flows over 6 gpm at 26 psi (most pumps will have long since stopped flowing at these pressures).

Why is this important - because you aren't using this pump to pump a garden hose. Intercoolers, radiators, other heat exchangers, engine blocks, hose fittings, etc. all generate significant flow restriction and back pressure and if your pump can't flow against that pressure you aren't getting the flow you think you are.

This pump consumes over 330 watts (25 amps x 13.5 volts). If your pump is using a lot less watts (drawing a lot less current) chances are your pump flows a lot less fluid too.

High current, high efficiency DC brushless electric motor
Long life design (10,000+ hour target lifespan)
1" inlet and outlet connection fittings
Cast 413 aluminum alloy housing
9-18 volt DC operating range
Variable speed capability via J1939 (requires CAN input to pump)

These pumps are programmed for a maximum current limit of 25 amps and a maximum pump speed of 4600 RPM. This is the maximum performance capability configuration for this pump.

The pumps are configured to operate via external CAN control or stand-alone.

In the absence of a CAN signal, the pump will behave as a simple on/off control pump. The built-in pump controller will wait 5 seconds on initial start to check for the CAN signal. When the pump controller does not see the CAN signal for 5 seconds it will then go into stand-alone operating mode (simple on/off control mode).


Model #:WP29

Part #:1030002157

Power and enable wiring harness
CAN control connector with cavity plugs (cavity plugs needed unless using CAN wires)
Installation instructions

New in box
Old inventory

Country of origin:
Made in the USA

Also available without the wiring harness.

Quantity discounts available.

See our web site page for this product for more information:

Business Phone Number: This user has not entered a phone number yet.
Send message to seller below.
This item is NEW
Payment options:
Item Location: FORT WAYNE, IN Get Directions To This City
Instructions for buyer: Please contact us via email or Rackingjunk message if you have any questions.
Contact Business
This ad expired 88 days ago.
From:    To: 
Business Information

Ad posted by:
proserv (#732592)

Product & Service Solutions LLC
6435 West Jefferson Blvd.
Fort Wayne, IN 46804
(260) 547-2255 Contact
Business Website
Member Since: 2014-03-21
Member Feedback
Number of Honor Payments: 0
Average Accepted Sale Price: $0.00
Average Honor Payment: $0.00

Print Ad
Enter Friend’s Email:

Report the sale - click here

106 Main Street, North Adams, MA 01247
Toll Free: 866.326.9227 • Tel: 413.663.3496 • Fax: 413.663.3615 • Email: support@racingjunk.com

Execution Stats: 0.273 sec / 16.2 MB used / 16.4 MB peak