This JBR PSI injector will keep the butterflies down on the blower where vision of the tree may be needed and make it easier for a driver in a pro mod or funny car to stage. Injector is sold as in the pictures but can be made complete if the customer likes at additional cost at time of purchase. Injector butterfly square inch area is 74 in. and weights eleven pounds as seen in the pictures. Height of the injector is 6.00" and opening in the injector is full open back design. Injector housing has been drilled 1/8" pipe in five spots on the rear for fuel nozzles which can be plugged. From center of front mounting stud which can be seen in the pictures the injector sticks out 5.00" forward. Injector has four 4.750" x 4.250" square alum. butterflies and injector housing has provisions on both sides for barrel valve mounting as well as throttle cable bracket mounting using 1/4" hardware. Injector has air diverters built inside to help direct airflow into the blower and divider hangs down below the injector mounting surface two inches to get close to the blower rotors. Includes a 1/4" alum. mounting plate to mount the injector to the blower. Lots more pictures on www.rbssuperchargers.com, part number 7003-0034D .
Expires on: 01/12/2017
Posted: 10/20/2016, ad expires in 79 days
Business Information Ad posted by: