FREE SHIPPING 48 STATE BUSINESS ADDRESS ONLY. WITH LIFT GATE.
$40.00 SHIPPING TO A RESIDENTIAL ADDRESS.
Not looking to break the bank chasing Chrome Valve covers, and Billet Air Cleaners? These Pace Budget Series Engines are for you! Pace Performance has put together these wallet friendly options with quality, yet cost effective parts to keep more green in your pocket! We even treat these Engines to the same prime and prep procedures as our other offerings! You can’t beat the value!
Pace Performance Budget Chevy 350 260HP Engine Includes:
• Pace engine prep and oil priming service.
• Aluminum Performance Intake
• Holley 600CFM Vacuum Secondary Carb with electric choke
• Fuel Pump and Fuel Line to Carb
• Chrome 14” Air Cleaner
• HEI Distributor, Plug Wires, Looms and Plugs
• GM OE Black Steel Valve Covers
• 14” Auto Trans Flexplate
• HD Starter and Bolts
• 6” Harmonic Balancer
• Performance Aluminum Long Water Pump (short water pump available upon request)
• Oil filters
• 5 Quarts of Zinc enhanced break in oil
• *Includes 4 Quarts shipped in Pan, and 1 extra quart for after filter is installed
General Motors limited 1 year parts only warranty
Pace Fully Assembled "Brand New" 350CID 260HP
This turn-key GM 350CID engine comes fully assembled using a brand new (not remanufactured) GM 10067353 350cid 4 bolt main long block. We have preinstalled all name brand components needed to make this engine ready to run, right out of the crate.
Power: 260 HP @4300 RPM, 350 ft. lbs. of torque @ 3600 RPM
Displacement: 350 CID, 5.7L
Bore x Stroke: 4.00” x 3.48”
Compression Ratio: 8.5:1
Recommended Fuel: 87 Octane
Block: Cast Iron, 2 piece rear seal, 4-bolt main caps
Crankshaft: Nodular Iron
Connecting Rods: Powdered Metal Steel
Pistons: Cast Aluminum
Camshaft: Hydraulic Flat Tappet
Cam Lift: .383” Intake / .401” exhaust
Cam Duration @ .050”: 194 deg. Intake / 202 deg. Exhaust
Lobe Separation: 112 Degree
Cylinder Heads: Cast Iron, 3/8” pressed in rocker studs
Combustion Chamber: 76cc
Valves: .194” Intake/ 1.50” Exhaust
Rocker Arms: Stamped Steel, 1.5:1 Ratio
Maximum GM Recommended RPM: 5100
Ignition Timing: Base 10 degrees BTDC, 32 degrees total
Cylinder Head Notes: 7 Bolt style Exhaust Flange Standard, 85' and prior intake manifold bolt pattern. Perimeter bolt style Valve Covers. This head is very similar to the old #882 castings from the 1970's.
Block Notes: Clutch Z-Bar hole is drilled and tapped for manual trans applications. Engine mount holes drilled and tapped for both early-style front motor mount brackets and the normal side motor mounts.
Paypal, Money Order, Credit Card, Cash
Expires on: 12/31/2016
Posted: 10/08/2016, ad expires in 67 days
Business Information Ad posted by: