Ford Mustang 8.8" Welded, 9" big housing ends - $650

$650
Private Seller - nanotoxin55
Asbury, NJ

Buyer Resources

Shipping

Compare shipping quotes and save up to 80%

Secure Transactions

Secure your transactions with Escrow.

Report This Ad

Item Details

Ad Number182753064
ConditionNew

Description

Hey all, getting rid of a couple bare 8.8 housings I don't need. Both were professionally done on a jig. Tubes straightened if needed, tubes then welded 360 degrees on a jig to the center section and 9" big bearing ends welded on. Housings were cleaned inside, sand blasted outside and fully powdercoated on the outside. Damper brackets have been removed to allow welding of the 9" ends.

Housing 1: 55" Brake flange to brake flange
Housing 2: 56.5" Brake flange to brake flange

They will obviously need gears, carrier, bearings, etc. with custom axles you can order from probably any axle manufacturer. I personally use Strange Engineering. Call them up tell them it's an 8.8 with the Ford 9" big bearing ends and it's X" flange to flange measurement and they will be able to make you an axle set and give you the overall axle flange to axle flange width once axles are installed.

Housing 1 is close to a factory Foxbody and will probably push the wheels about 1/4" further out, or be good for a tubbed 96-04 if you need a shortened rear or to use some really deep dish wheels.

Housing 2 will pull the tires in 1/4" on each side for a 99-04 so you can use a deeper dished wheel, or can probably be used in a 96-98 also depending on wheel offset.

Looking for $650 each picked up in Clinton NJ area. The work and parts alone will cost close to this, nevermind the cost of the rear itself and the 2-3 month wait time most shops have. If you want both or you and a buddy want to take them both at the same time, I will let them go as a package, but you must take both on the same day.


Here is a picture of the 55" housing, but they're both identical apart from the actual measurement. The white spots on the 9" end is not flaking powdercoat, it's just tape residue from me keeping the ends covered. Both housings are recently powdercoated and have not been used since the work was performed, so there are no issues with them at all.

Payment Details

TradesAccepted: Stock 99-04 Mustang 8.8" rear end housing. Will take with or without internals. Only need a good housing.
Accepted Payment Methods Cash

Message Seller

Send Message

About The Seller

PRIVATE SELLER
nanotoxin55
Member Since January 2008
CONTACT INFORMATION
Asbury, NJ 08802
9088925903
Learn More
0 Honor Payments
No Achievements Yet
Honor Member Bronze Seller Silver Seller Gold Seller Power Seller
Get Transportation Rates

Location

ASBURY, NJ
Similar Classifieds
Email us - Support@racingjunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy


Execution Stats: 0.197 sec / 10.3 MB used / 10.5 MB peak