This is a two piece design rear driveshaft enclosure. What is great about this two piece design is that the mounting bracket gets bolted directly to the pinion support. The enclosure (can) then gets bolted to the mounting bracket that is already mounted to your pinion support. This means that you don't have take you pinion support bolts in and out every time you need to access to the driveshaft. You loosen up the enclosure and then slide it back on the driveshaft for easy removal of the drive shaft or third member. Also, you only need a one 9/16" wrench as the mounting studs are welded to the mounting ring. This two piece enclosure fits Ford 9" five bolt pattern or Ford style 9.5" ultra case. It will also fit a 1480 U-joint as well.
Please specify when ordering if pinion is 5 bolt Strange or Mark Williams or if you have a 12 bolt specify if tapered pinion or ball bearing pinion. 12 bolts are slightly higher in cost.
Main picture is for the 9' Ford style and the second picture is for the 9.5" ultra case.
"For all classes which require a rear driveshaft loop this design is permitted by NHRA" per NHRA.
PROUDLY MADE IN USA and powder coated.
Any questions, call 630-904-7755 and ask for Bill.
Paypal, Money Order, Credit Card, Cash
Shipping Is $21.95 Continental US. NO AMERICA EXPRESS
Expires on: 12/17/2016
Posted: 08/27/2016, ad expires in 52 days