The car is in good shape great first car can drive car runs and drives well. I have replaced some parts on the car so I could drive it while working on it.
No rust on the car under carriage and floor pans all good.
New front brakes, rotors, bearings ,pads calipers and hoses.
New exhaust dual 2 1/4 ID through magnaflow mufflers.
Fixed A/C it blows cold fixing duct work in the car also.
Tuned up car new set of plugs Cap Rotor and wires ok. Also se timing and adjusted Idle.
Tires are in good shape lots of tread.
I was in the middle of getting car prepaired to do a lot of work to the car I have a 455 Pontiac short block It has a Lunati 268 VOODOO cam shaft, also baffled oil pan, full length windage tray, one piece oil pan gasket, New 455SD oil pump, New double roller timing set, Fully balanced, New balancer, New 455sd Water pump, and new timing cover.
I also have a set of 6x no 8 Dport heads taken apart I have not had time to work on them I was going to clean up ports and get them machined and ready for assembly. I have not had the time I have all the valves needs new springs for the camshaft. I have the spec card for camshaft.
This can be sold with the car. or seperatly. I also have brand new motor mounts for the engine conversion.
The car is in really good shape. Interior has a few scratches and some panels will need to be repainted. New seals will need to be done on doors . Windshield has a crack in it. And the dash has 2 splits but has a dash mat. These were all hear when I bought the car was going to redo car I have moved and have not had time or money to work on the car.
Will Trade for Jeep CJ 7 ,or TJ also Pontiac Fiero 87 or 88 GT