.4 Port Blower Hilborn 6-71 8-71 14-71 Injector-TALL
Same as when it was designed in 1963
NEW in stock with polished or unpolished Scoop
* 3" butterflies are good for any racing application, or tunnel ram application, serious gasser or blown racing.
2-3/8" butterflies are good for EFI cnversions, street use, low boosted engines, small engines with tunnel ram like sB Chevy- see other listing for small butterflies
High capacity barrel valve for 50% or more nitro precentage
4 extra nozzles and lines for 25 lbs of boost or more or engines over 500 cu in or for 50% or more nitro
Hilborn 6-71 8-71 10-71 Blower Injector. 2-3/8" or 3" Butterflies
Not a Repro, but a Brand New from Hilborn built for me.
Will fit a 6-71 8-71 10-71 14-71
Our Casting Disclaimer:
Hilborn and Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.
There are casting flaws that have been there from the beginning and will always be there. We cannot do anything about this and the manufacturers will not.
In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries. It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out.
We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.