For Sale: 1986 Porsche 944 Turbo 951 Enduro PCA
Allright here is the story...
Link to 100 photos of car on photobucket
I bought this car last year from one of my clients to race the Local 8 Hour enduro and the 25 hours of Thunderhill.
So I took the car to get completely prepped for the races ahead. It was already a Porsche Club of America PCA race car that was grouped in to GT3-S and SCCA ITE. So as a race car it was very complete and competetive. I had the car setup with a quick fill endurance fuel filling system and a Piaa lighting system thhat could be put on quickly for the night time runs.
In prepping the car we went through the car completely, and added some more performace and reliability items. Most all parts came from Lindsey Racing.
Brand New Light Weight Racing Clutch, Lidsey Racing stainless header, Complete exhaust system, 3" turbo to muffler and 4" back, Godzilla blow off valve, new fuel pressure regulators, new coil, all new wheel bearings, New rotors and Enduro Carbotech brake pads, Rebuilt limited slip rear diff and bearings, Stohr Carbon fiber rear wing center mount all custom, Lidsey motor and transmission mounts. New Water pump and timing belts, and re sealed engine completely, new starter, master cylinders, fuel injection harness, lindesy racing MAF and intake.
It already had the full cup style suspension with adjustable camber plates and full mono ball suspension, sway bars with adjustable ends, brake ducts, newer 996 brake calipers, stainless brake lines, oil cooler, OMP racing seat, we put in new harness belts, Roll cage with 1.5" main hoop and side bars.
I spent about $15k in getting the car ready for the races. But... in the first race in the 6th hour when a new driver got in and miss read the tachometer sticker (with the upgrades and more boost it redlines at 5500 RPM not the 7800 that the tach show, overboosted the motor and blew the head gasket...)
So again we pulled the motor out and I bought a used 951 engine and had it fully rebuilt, all new valves, piston rings, bearings, seals, and racing updates. When we took it apart I found that tha turbo had a bad vane on the intake side so I had it updated to a KKK/Garrett hybrid that has more midrange boost and quicker spooling (it cost $1400). I have not run the car since it was redone so, it is all fresh.
It also has a fiberglass light hood and front bumper with splitter, AMP transponder with laptimer, sliding seat rails, omp steerign wheel with quick disconnect, oddessy light battery,
The car comes with lots of spares too
Two sets of 18" CCW Wheels ( one set is new never run )
New brake rotors never used
New Fuel pump and filter
New Brake Pads front and rear Carbotech
Brake and Clutch master cylinders
Full set of lug nuts and other hardware
Used Race 951 engine with bad headgasket- I did not take it apart as-is
and more stuff that I am forgetting
I just broke it in on the Dyno 10-11-2011, We ran in lightly it had 345 hp, running rich. Last year after it was all tunned up and broke in 385hp.
I have Dyno Sheets!
Call me for more information 503 819 9007 Matt
This item is USED
Ad posted by:
Member Since: 2005-11-05
Phone Number: 5038199007
Number of Honor Payments: 0
Average Accepted Sale Price: $0.00
Average Honor Payment: $0.00
- Member has no other classified ads.
Report the sale - click here